1961 Light/Vent/Wiper Knobs
1961 Light/Vent/Wiper Knobs
Good day,
Changing some wiring, and wanting to know how to remove the knobs without damaging them. I know about removing the threaded collar holding the module in place, but not how to safely get that black knob removed. Help?
Changing some wiring, and wanting to know how to remove the knobs without damaging them. I know about removing the threaded collar holding the module in place, but not how to safely get that black knob removed. Help?
1961 Dodge D-100
Alberta, Canada
Alberta, Canada
- dodgeboykim
- Sweptline.ORG Pioneer
- Posts: 3018
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Chilliwack. B.C. Canada
- State: Foreign
- Location: chilliwack.
Re: 1961 Light/Vent/Wiper Knobs
Set screw in side. Light switch has a hidden button on switch behind dash. Some disconnect cable from heater etc and pull through holding bracket.
Have to figure out removal for each item.
Have to figure out removal for each item.
My truck is younger than me.
66 W100. 70 D 500 , 69 Hiab Speed Loader. 96 Ram 3500 Club Cab Cummin's 5 spd. 97 Ram 1500 Club Cab 5.9 gas auto. 83 W200 LB Propane 360 auto 09 Yammy Rhino 700.
66 W100. 70 D 500 , 69 Hiab Speed Loader. 96 Ram 3500 Club Cab Cummin's 5 spd. 97 Ram 1500 Club Cab 5.9 gas auto. 83 W200 LB Propane 360 auto 09 Yammy Rhino 700.
Re: 1961 Light/Vent/Wiper Knobs
Thank you. I couldn't find a set screw, but I'll keep looking.
1961 Dodge D-100
Alberta, Canada
Alberta, Canada
- dodgeboykim
- Sweptline.ORG Pioneer
- Posts: 3018
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Chilliwack. B.C. Canada
- State: Foreign
- Location: chilliwack.
Re: 1961 Light/Vent/Wiper Knobs
What knob in particular are you looking for a set screw on.
My truck is younger than me.
66 W100. 70 D 500 , 69 Hiab Speed Loader. 96 Ram 3500 Club Cab Cummin's 5 spd. 97 Ram 1500 Club Cab 5.9 gas auto. 83 W200 LB Propane 360 auto 09 Yammy Rhino 700.
66 W100. 70 D 500 , 69 Hiab Speed Loader. 96 Ram 3500 Club Cab Cummin's 5 spd. 97 Ram 1500 Club Cab 5.9 gas auto. 83 W200 LB Propane 360 auto 09 Yammy Rhino 700.
Re: 1961 Light/Vent/Wiper Knobs
I was looking on the light knob, but I'll look for the hidden button, too.
1961 Dodge D-100
Alberta, Canada
Alberta, Canada
-
- Sweptline.ORG Pioneer
- Posts: 7384
- Joined: Wed Dec 31, 1969 6:00 pm
- Location: Walnut Creek, CA
Re: 1961 Light/Vent/Wiper Knobs
There is no set screw on the light knob. It is molded to the shaft that pulls out of the switch after pressing the release button located between the wire connection tabs. Can be a PITA.
Re: 1961 Light/Vent/Wiper Knobs
I was fooling with it and no luck yet...may just end up doing the wiring with it still attached.
1961 Dodge D-100
Alberta, Canada
Alberta, Canada
- Txas2step
- Sweptline.ORG Pioneer
- Posts: 3416
- Joined: Mon May 31, 2010 7:26 am
- City: houston
- State: TX
Re: 1961 Light/Vent/Wiper Knobs
This is the button on the switch you have to push in to release the shaft. Takes a few tries sometimes.
- Attachments
-
- s-l1600 (7).jpg (8.64 KiB) Viewed 4936 times
61 shorty 170/ 3spd 3:91(sold)
66 lwb 318 poly/727/4:10 (sold)
67 shorty 318poly/4spd 3:55
68 ute 318/3 spd/3:55(sold)
70 318/727/3:23
66 d200 225/4spd/4:10( military)(sold)
68 d100 383/727/3:55
66 lwb 318 poly/727/4:10 (sold)
67 shorty 318poly/4spd 3:55
68 ute 318/3 spd/3:55(sold)
70 318/727/3:23
66 d200 225/4spd/4:10( military)(sold)
68 d100 383/727/3:55
Re: 1961 Light/Vent/Wiper Knobs
think you have to push it down before you start pulling on it