Interior is in!
- dylansd100
- Sweptline.ORG Member
- Posts: 148
- Joined: Wed Dec 31, 1969 6:00 pm
- Location: charlotte, nc
- Contact:
- hotrodjohn68
- Sweptline.ORG Member
- Posts: 133
- Joined: Wed Dec 31, 1969 6:00 pm
- Location: Friendswood ,Texas
nice
kickpanels look good !!!!!!
i cant wait to see some better pics of those in the truck. i like the radio an spkr. nice setup for the price !
they look great. . hope to be building some more of those kickpanels for others tell me how they for u . thanks tom.
john
i cant wait to see some better pics of those in the truck. i like the radio an spkr. nice setup for the price !
they look great. . hope to be building some more of those kickpanels for others tell me how they for u . thanks tom.
john
- MountainMoparRobin
- Founding Member
- Posts: 7854
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Lakewood
- State: CO
- Location: Lakewood Colorado
interior in
That is nice tom and the kick-panels seem to blend right in
Those are pretty! I think my truck is going to need those when Im done. If you or John dont mind me asking, how much is he asking for a set?
Oh, and dont they cover up the dimmer switch? Or isnt it on the floor in the later trucks?
Oh, and dont they cover up the dimmer switch? Or isnt it on the floor in the later trucks?
1967 Dodge D200 5.7 HEMI/5speed
1971 Dodge Challenger #'s 383/727
1974 Dodge D600 318 5+2
2003 Ram 2500 Cummins HO
1971 Dodge Challenger #'s 383/727
1974 Dodge D600 318 5+2
2003 Ram 2500 Cummins HO
John's good
Dimmer switch is on the floor but John is good. I've only seen pictures but they don't appear to interfere with access to the dimmer switch. A little too spendy for me right now but maybe someday. Since I passed the 55 mark I find dependable is more important to me than pretty. But am planning on both as money allows. Edelbrock 500 next, then...Oh well it's a never ending list. Great job guys.
-
- Sweptline.ORG Member
- Posts: 770
- Joined: Wed Dec 31, 1969 6:00 pm
- City: LaA
- State: CA
- Location: CA
Dimmer switch was close but I unscrewed it from the floor and moved it to the right as much as the dent in the floor pan would allow. You can't see it in this picture but not a problem. You do need to relocate the vent pull which you can see mounted to the underside of the dash in one picture, I used a small piece of extrution I had. No big deal.
You need to contact John for price, he puts a lot of work into these.
Blue67 your just a kid I just passed 65 in Oct.
You need to contact John for price, he puts a lot of work into these.
Blue67 your just a kid I just passed 65 in Oct.
-
- Sweptline.ORG Member
- Posts: 770
- Joined: Wed Dec 31, 1969 6:00 pm
- City: LaA
- State: CA
- Location: CA
Re: hehehe
Roger that, one of the reasons I keep wanting to swap the engine from my Dart to the truck before I sell the Dart.Blue67 wrote:Tom. I'll be a lot younger when I get the 4 barrel manifold on I bought from Jimmy and the new Edelbrock 500. Or maybe I'll just start getting tickets again. hehehe