ignition switch wiring

greenmachine318 · Post by **greenmachine318** » Fri Nov 03, 2006 7:05 pm

help please? i have to rewire my ignition switch in my 69 d100 any help or pointers would be greatly appreciated thanks.

Roger · Post by **Roger** » Fri Nov 03, 2006 7:39 pm

Jim, don't you have a link to the wiring diagram on this?

mopardwh · Post by **mopardwh** » Fri Nov 03, 2006 7:42 pm

What's wrong with it?

greenmachine318 · Post by **greenmachine318** » Fri Nov 03, 2006 8:15 pm

well the harness that plugs into the back of the switch is all wired in right i just need to run the wires to the fuse box or where ever they go and to be quite honest im retarded with wiring. i know the simple stuff but im just confused as to what goes where as far as coil, starter, and battery.

Jeffc · Post by **Jeffc** » Sat Nov 04, 2006 12:50 pm

Switch has marks by each post on the back.
List as follows:
Starting at the top post marked "A" with org. color and wire gauge

A> accessory to wiper switch 12g Light Blue with
splice to fuse box alt reg fuse and 14g red to fuel gauge (buss bar on amp guage)<<12g LB This is the wire
that hooks to the braker on the back of the
wiper motor switch.>>

S> (just below A) 14g orange to fire wall> runs to
the start post on the starter relay

I-2> (to the right side of "I" if not marked)14g pink to ballast resistor- same side as coil
"+" wire

B> above "B" not marked 2 wires
18g blue with white stripe- to brake sentinel switch on brake line spliter box- 18g blue with white stripe
to warning light on dash

B> below "B" - 10g black this wire runs many things-
runs to splice- that then goes to back of amp gauge (10g red), fuse block (10g red), light switch (16g dark blue), Alternator (10g black)

I> 2 wires, 18g black runs to oil pressure light,
16g red runs to fire wall and then to ballast (side
with one wire).

I belive this is all correct.

hope this helps Jeff

greenmachine318 · Post by **greenmachine318** » Sun Nov 05, 2006 3:52 pm

Jeffc wrote:Switch has marks by each post on the back.
List as follows:
Starting at the top post marked "A" with org. color and wire gauge

A> accessory to wiper switch 12g Light Blue with
splice to fuse box alt reg fuse and 14g red to fuel gauge (buss bar on amp guage)<<12g LB This is the wire
that hooks to the braker on the back of the
wiper motor switch.>>

S> (just below A) 14g orange to fire wall> runs to
the start post on the starter relay

I-2> (to the right side of "I" if not marked)14g pink to ballast resistor- same side as coil
"+" wire

B> above "B" not marked 2 wires
18g blue with white stripe- to brake sentinel switch on brake line spliter box- 18g blue with white stripe
to warning light on dash

B> below "B" - 10g black this wire runs many things-
runs to splice- that then goes to back of amp gauge (10g red), fuse block (10g red), light switch (16g dark blue), Alternator (10g black)

I> 2 wires, 18g black runs to oil pressure light,
16g red runs to fire wall and then to ballast (side
with one wire).

I belive this is all correct.

hope this helps Jeff

hey jeff thanks a lot that broke it down for me i can now turn key haha