64W200 wire diagram

[lbman]

ok . like so many wires under dash and pretty much everywhere else are messed up. .
I can get wire from trash cans at work.lol but i sure would like a pic of where to terminate my new wire. there are so many splices and reconnections. geezz. someone or many others have been wiring around factory switches that the previous owner installed a big rotory swi on the floor by shift lever to shut off all power from battery so batt would not go dead. W.O,W
i figure this is a fire waiting to happen not to mention and along side the road dead truck repair...been there done that.
Mcgiever would be shocked !!! its soooo bad Rats would not move in.. ;-}
anyways if someone has a wiring diagram i sure would be greatfull .
thanks,
LB

[Hobcobble]

Here ya go...
http://www.sweptline.com/tech/62_65wire.jpg

Welcome to the site!
John

[lbman]

thanks for the quick response John
this will do me fine. now all i have to do," is do it."
most of the factory plugs going through firewall have been bypassed . there are 8 wires going to the back tail lights.
looks to me there is not a lot of stuff going on here. very basic indeed.
i figure i will cut most of the stuff out and start from scratch. i can leave some end intact for color coding .
suppose i will find the factory switches have failed hence all of the wire and yellow wire nuts . and a few added switch's 2 of which do no work either. where would be a good source for the original Style switches?.NAPA perhaps.
thanks again for the help
LB

[Hobcobble]

thanks for the quick response John
this will do me fine. now all i have to do," is do it."
most of the factory plugs going through firewall have been bypassed . there are 8 wires going to the back tail lights.
looks to me there is not a lot of stuff going on here. very basic indeed.
i figure i will cut most of the stuff out and start from scratch. i can leave some end intact for color coding .
suppose i will find the factory switches have failed hence all of the wire and yellow wire nuts . and a few added switch's 2 of which do no work either. where would be a good source for the original Style switches?.NAPA perhaps.
thanks again for the help
LB

NAPA can help on the ignition switch, dimmer switch and headlamp
switch. For others such as the blower, wiper & brake light switches,
you can put an ad in the Parts Wanted section.
John

[muddyoldman]

Hey John , Where can I find a 68 W100 diagram? thanks , Jim

[junior]

Installing a fusible link would be a good idea to help ever prevent a fire

[Hobcobble]

Hey John , Where can I find a 68 W100 diagram? thanks , Jim

Right here Jim....
http://www.sweptline.com/tech/68wire.jpg

John