going to make the swap
-
prosparky475
- Sweptline.ORG Member
- Posts: 40
- Joined: Tue Feb 16, 2010 4:57 pm
- City: Omaha
- State: NE
going to make the swap
I'm going to swap the 318 for the 383. I found the right bell housing but my dumb question is will my flywheel clutch pressure plate from my small block work or do I have to get new ones for the big block set up?
-
dodgeboykim
- Sweptline.ORG Pioneer
- Posts: 3066
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Chilliwack. B.C. Canada
- State: Foreign
- Location: chilliwack.
Re: going to make the swap
Double post.
Re: going to make the swap
Sir
Before you start taking off and away The A-318 Items do make sure you have a Oil Pan on The 383 which fits
the space for The Truck.
How about The Big Block Motor mounts and a set of Center Dumping Exhaust Manifolds.
Rodger & Gabby
FltSgt@outlook.com
COS
Before you start taking off and away The A-318 Items do make sure you have a Oil Pan on The 383 which fits
the space for The Truck.
How about The Big Block Motor mounts and a set of Center Dumping Exhaust Manifolds.
Rodger & Gabby
FltSgt@outlook.com
COS
-
Roxyflash
- Sweptline.ORG Member
- Posts: 705
- Joined: Sat Nov 06, 2010 6:47 pm
- City: East Moline
- State: IL
Re: going to make the swap
Hydraulic bell or standard linkage bellhousing?
-
prosparky475
- Sweptline.ORG Member
- Posts: 40
- Joined: Tue Feb 16, 2010 4:57 pm
- City: Omaha
- State: NE
Re: going to make the swap
Its not a hydraulic clutch. Found the bell housing from brewers performance. Still looking for the mounts and oil pan.