I've got an 8 3/4 SureGrip 3.91 rear end that has the slines on the ddriver axle 'buggered' up from the previous owner, this is from a 1965 D100. Found an axle from a '73 Dodge Adventurer with an 8 3/4 rear, same spline count. Wondering if there is a overall length difference in these two axles.
Here's the reason for asking; pline count was the same and diameter was the same, so I installed the '73 axle into the '65 rear end. Needed to replace the inner axle seal on the passenger side so I did. Now I'm having difficulty reinstalling the passenger axle, even BEFORE having to adjust the end play. I bolted down the 5 nuts on the flange and the axles are difficult to spin with the truck in neutral...and it's not the brakes dragging...drums aren't even installed.
Any ides?
Wayno
Austin, TX
Axle length question
-
- Sweptline.ORG Member
- Posts: 129
- Joined: Sun Feb 27, 2011 9:56 pm
- City: Austin
- State: TX
- Location: Austin, Texas
- Contact: