a833od tranny to a slant six 1967

[PDQAUTO]

need a bellhousing to mount to my 225/6 for a a833od tranny the 3 speed one does not work and the 84 th tranny came out of does not have the mounts will the np 435 bell housing work and does any one know where to find one

[Hobcobble]

need a bellhousing to mount to my 225/6 for a a833od tranny

the 3 speed one does not work and the 84 th tranny came out of does not have the mounts

will the np 435 bell housing work and does any one know where to find one

The NP420 4spd, NP435 4spd and A745 3spd hydraulic
clutch bell housings are one in the same for both the
Slant Six and Small Block V8.

I don't know of a bell housing out there that would
use the same cross member as the '61-'68 stock
hydraulic clutch bell housings.

In order to install this A833 O.D. tranny, you may have
to find a later bell housing, cut the original bell housing
cross member from your truck's frame and install another
cross member to accept the tail-shaft mount.

Hang tight. Some who have gone this route with a
pre-'69 Sweptline can fill you in with particulars.
John

[PDQAUTO]

went back to junk yard and got bell housing and flywheel that is all installed todays feet will be to install tranny and tranny mount

[PDQAUTO]

need to modify a clutch fork to work with my hydrolic clutch need to have a drill press to drill a hole in hardened fork steel will bring to shop tomorrow