would the rough country lift kit for the 70-74 ramcharger/trailduster work on a 66 dodge. just looking for a 4" lift for it so if any of you got any other company please share it with me i just realized how hard it is to find them/not enough funds for this truck
http://www.rockymountainsusp.com/dodge6 ... harger.htm
thanks!
Rough Country lifts?
- 66militaryd200
- Sweptline.ORG Member
- Posts: 103
- Joined: Sat Jan 28, 2012 9:51 pm
- City: Dallas
- State: OR
- powerwagoncrazy
- Sweptline.ORG Member
- Posts: 615
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Hubbard, OR
- State: OR
- Location: Hubbard, OR
Re: Rough Country lifts?
Will it work? Yes. But it won't actually lift the truck any. A 5" lift spring for a '69-'93 is the same arch as a stock spring in a '68 and earlier Power Wagon (based on my previous experiences). Just wait until you get the 4x4 axle under there first- I think you'll be pleasantly surprised with how much taller your truck sits
Re: Rough Country lifts?
I agree with Rob.
John
John
- 66militaryd200
- Sweptline.ORG Member
- Posts: 103
- Joined: Sat Jan 28, 2012 9:51 pm
- City: Dallas
- State: OR
Re: Rough Country lifts?
ok, didnt know that. but my truck needs something because i can see it sagging on the drivers side . might head to local pick a part for temperary springs till axle swap. what springs will fit on a 66 d100 also which have the biggest arc in them?
Re: Rough Country lifts?
D100?66militaryd200 wrote:ok, didnt know that. but my truck needs something because i can see it sagging on the drivers side . might head to local pick a part for temperary springs till axle swap. what springs will fit on a 66 d100 also which have the biggest arc in them?
John
- powerwagoncrazy
- Sweptline.ORG Member
- Posts: 615
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Hubbard, OR
- State: OR
- Location: Hubbard, OR
Re: Rough Country lifts?
Well, anything from the front of a '61-'93 W100/150 200/250 or '61-'71 D100/200 will bolt into your truck, be the correct length, and have the center pin in the right spot. That said, '69 and later W series trucks have a significantly smaller factory arch and will actually lower your truck. I believe the tallest- arched springs Dodge used in the '60's were found in D100's and D200s, so I'd recommend finding springs from either of those- probably a D200 just to keep your ability to pack some weight. Or you might just try sticking another leaf in your drivers' side spring pack.
The other option is to find some used lift springs from a '69-'93 truck or a Ramcharger- they do pop up on craigslist pretty cheap from time to time.
The other option is to find some used lift springs from a '69-'93 truck or a Ramcharger- they do pop up on craigslist pretty cheap from time to time.
- 66militaryd200
- Sweptline.ORG Member
- Posts: 103
- Joined: Sat Jan 28, 2012 9:51 pm
- City: Dallas
- State: OR
Re: Rough Country lifts?
Oh wow been awhile since been on here been busy with school and baseball to. But also working on my trucks when ever possible and was crawling around under my truck and discovered that the top of the rear shocks were almost in the center of the cross member. So I put it back to how it was with the shocks being more vertical and tightened up the compression springs on the shocks and that lifted the rear end a good 3 or 4 inches