replacement floor panels source,

[68crewcab]

Howdy, I have a 1968 air force w200 crewcab with the big nuckel dana44 the 3500 version and am looking for all the sources for replacmeent panels especially the left front floor board, i would buy a used cut out of any side with the wheel well and am also looking for the seat belts for front and rear of the crew cab and there mounting bolts as well. Also looking for factory winch bumper, cable in dash and the t/c mounted pto, pto drive shaft with bracket, and a correct winch or any of the above, also need a tail gate, hinges and chains for the tail gate as well. I have a short stepside bed on the back of this w200 with 225 and 4 speed, also looking for a complete good used wiring harness as well,factory parts manual for a 68w200, I pay cash if somebody can send good digital pics of what u have. I also would like a rear floor out of a crew cab too if any are out there?? I am in Central texas and can pick up or even buy a crewcab parts truck if not too far out of state, Thanks!!!

[Hobcobble]

Copy this into the parts wanted section. You can get
floor pans [front] from:
http://www.vintagepowerwagons.com
Others from the forum will probably be able to help
out on the other parts. Winch?.... LU-2? MU-2?... you
could try Mark DuVerger at:
http://www.marksmopars.net
He has an LU2 for sale. I'm not sure as to whether
he has all the hardware though. Check with him.
Also, you can post a wanted ad at:
http://www.powerwagonadvertiser.com

Welcome to the site
John

[dodgetkboy78]

i just got a whole load of stuff (floors and rockers )from autobody specialists. the step plates arent quite origonal looking, but the floor is pretty nice

[68crewcab]

thanks for the tip, I have seen the place where vintage powerwagons gets there floorboards and that is what i am looking for, they are a lot cheaper too, I keep finding the steps but not the floorboards, who makes them for vpw?? anybody body got any used that are for sale, I need both sides ands also a back floor out of a crewcab and all the seatbelets>??? L thanks

[Jims68]

Did you ever consider making them yourself? Go to this link for the floor repair, then, click on REPAIR TIPS, then click on BODYWORK. You can see the floor repair that I did on my 68. GO HERE:

http://www.dodgesweptline.org/

Plus, you might want to consider getting my 68 Dodge truck Restoration CD, Click on the WWW link below to see what it is about.

As for seatbelts, you may have to get two sets from the front seats for a 68, and not "specifically" front and rear.

Jim