i need a measurement
- wideblock
- Founding Member
- Posts: 5617
- Joined: Wed Dec 31, 1969 6:00 pm
- City: las cruces nm
- State: NM
- Location: Las Cruces, New Mexico
- Contact:
i need a measurement
i would like for one of you guys with an automatic shifted long bed d100 to takle me a measurement of the drive shaft length from the center of each u-joint cup thats attached to the drive shaft its self. i already am pretty sure i dont have the correct front yolk, so ignore that, i just need to know how long it is from the center of one ujoint to the other. i would also like to know if it is a one piece shaft or a 2 piece shaft with a carrier bearing. in the case of a 2 piece shaft, id need a measure ment on both shafts. thanks in advance.......
Trey
1965 CSS Utiline.
ex trucks:
70 D100
66 d100
66 d100
67 d100
69 d100
69 d200 crew cab
65 crew cab
66 d100
66 d100
"i don't know it all, but i know enough to be dangerous"
1965 CSS Utiline.
ex trucks:
70 D100
66 d100
66 d100
67 d100
69 d100
69 d200 crew cab
65 crew cab
66 d100
66 d100
"i don't know it all, but i know enough to be dangerous"
Tray, my 3spd is the long tail like the 727 if thats what your thinking, I can get it tomorrow if you'ed like , just post here or send to me at home , your long haired redneck friend :) :D :roll:
8)
8)
cowboy Alvin Tx
67 w100 318 3spd
2005 Ram 2500 CC Diesel 4x4 lwb
LAND OF THE FREE
BECAUSE OF THE BRAVE
67 w100 318 3spd
2005 Ram 2500 CC Diesel 4x4 lwb
LAND OF THE FREE
BECAUSE OF THE BRAVE
From Ser. #1492000-1548000 A727 trans. @ 62.25" from end of shaft
to center of bushing ring.
After Ser. #1548000 A727 long ext. trans. [sliding yoke] shaft @ 63.25" from end of shaft to center of bushing ring.
After Ser. #1548000 A727 long ext. trans. @ 64.25" from end of shaft
to center of bushing ring.
From '63-'68 manual sec. 16 pg 16-2 & 16-3.
This is a single tube drive line as is the A745.
John
to center of bushing ring.
After Ser. #1548000 A727 long ext. trans. [sliding yoke] shaft @ 63.25" from end of shaft to center of bushing ring.
After Ser. #1548000 A727 long ext. trans. @ 64.25" from end of shaft
to center of bushing ring.
From '63-'68 manual sec. 16 pg 16-2 & 16-3.
This is a single tube drive line as is the A745.
John