Good afternoon, I finally dove into this mess of a ‘71 cab and i am trying to replace the cobbled 1/4” plate fabricated front cab mounts however I would like to have some sort of measurements to reference to keep things square and level. They had 72 and up floor pans poorly welded in it too so I don’t have the pan to reference height off of.Does anybody have measurements or a blueprint?
Thank you!
EDIT: Just found what I needed. I searched the other day and didn’t see it. Sorry for the extra post. However any advice on this sort of reconstruction would be appreciated.
Thank you!
Anybody have Body mount blueprints?
- 71Lumberwagon
- Sweptline.ORG Member
- Posts: 15
- Joined: Mon Dec 04, 2017 9:04 am
- City: Hastings
- State: NE
-
- Sweptline.ORG Member
- Posts: 10
- Joined: Sun Mar 04, 2018 7:57 pm
- City: Hummelstown
- State: PA
Re: Anybody have Body mount blueprints?
I fabbed a couple for my rusty pig, 71 also. Cab back on so far so good but have not fit the doors yet