Hello all!
I have a 67 d100 cab that i want to use for my project but i would like to remove the big trim on the cab and doors as im not a huge fan of that look (personal preference not trying to offend anyone!) does anyone know the best way to do this? Id also like to fix any holes left by the trim obviously. Any suggestions are helpful thanks!
67 trim removal
-
- Sweptline.ORG Member
- Posts: 5
- Joined: Mon Jul 08, 2019 8:43 am
- City: Barrhead
- State: AL
-
- Sweptline.ORG Pioneer
- Posts: 7365
- Joined: Wed Dec 31, 1969 6:00 pm
- Location: Walnut Creek, CA
Re: 67 trim removal
There are nuts that hold the end clips on inside the door and cab. Middle clips pop out. MIG weld the holes and grind smooth.