Sweptline.ORG

Getting ready to paint the cab on my 70 D100.
The original A pillar decal is there and in good shape.
Would you guys suggest masking off and painting around the decal,which might lead to a paint ridge around the decal, or can I get a new decal made so I can remove the original and replace it after painting?

Are you talking about the Chrysler emblem on the right side only Fender? I've wondered why they only put this on the right side.

No, he's asking about a decal.

Picture of it??? I know that there are REPRO stickers for the cars... and some were/are interchangeable.

To answer the questions about the single Pentstar fender badge, it was placed low on the passenger side so that when the car was parked it would be seen by people walking.
Right hand drive vehicles (ie Australia) had the badge on the left fender.

The decal I’m talking about is inside the drivers door jam , at the front of the door; looks like a manufacture number decal and I’m guessing I can’t get another one, so I’m thinking I’ll have to mask over it when I paint as I doubt I can get a reproduction decal with the same number on it.

fireguyfire wrote: ↑

Wed Aug 07, 2019 9:15 am

The decal I’m talking about is inside the drivers door jam , at the front of the door; looks like a manufacture number decal and I’m guessing I can’t get another one, so I’m thinking I’ll have to mask over it when I paint as I doubt I can get a reproduction decal with the same number on it.

I don't think my '68 D-100 had one... that is why I was curious to know what decal you were talking about.

Mines a 1970; I’ll post a photo up when I get home in a couple of days.

http://www.ecsautomotive.com/productdesc.php?co=c&id=52