Hi all,
I read jim M section on how to adjust the hood. My passengers side rear corner is a mile high. After doing all he said, I still had to use just over 1/2 of an inch worh of shim!!! It did the trick, hood looks better than it ever did. I used about 1/4 of an inch on the drivers side. Are you guys using this much shim to get your hoods down in the rear?? Im guessing I have another problem somewhere If I have to shim it that much.
hood shim question
- Jims68
- Sweptline.ORG Pioneer
- Posts: 3126
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Edgewater Park
- State: NJ
- Location: Southern New Jersey
- Contact:
Re: hood shim question
The hinge most likely also has a lot of wear. The shims are just taking up that extra "slack"...