Four-Eye Sheetmetal Screw Size?

Daddiojoe · Post by **Daddiojoe** » Tue Aug 26, 2008 6:43 pm

I'm to the point where the sheetmetal with the holes for the headlights (could these properly be called nacelles?) are about as straight as I'm going to get them. The screws that held them to the bulkhead are long gone, so I need to know the screw size that holds the headlight surrounds (there, that sounds better) to the front end of the truck. There are just two screws on each surround.

Thanks for your help and expertise,

Joe

Daddiojoe · Post by **Daddiojoe** » Thu Sep 04, 2008 1:05 pm

OK, I admit, this was a dumb question. Sorry.

Post by **Hobcobble** » Thu Sep 04, 2008 7:08 pm

Daddiojoe wrote:OK, I admit, this was a dumb question. Sorry.

Nope

..... not a dumb question at all. My head lamp surrounds are held on by
3 tapered head phillips head screws. If I get the chance..... I'll measure one up.

John

Sweptline.ORG

Four-Eye Sheetmetal Screw Size?

Four-Eye Sheetmetal Screw Size?

Re: Four-Eye Sheetmetal Screw Size?

Re: Four-Eye Sheetmetal Screw Size?