68 D200 383 w/ECU conversion Voltage problems

Wiring, lights, heater controls, anything electrical..

68 D200 383 w/ECU conversion Voltage problems

Postby Rusty69 » Wed Mar 22, 2017 9:32 am

Key off 12.6V key on 10.4V. Starts and runs but voltage stays at 10.4 except battery 12.6V. Is it the starter switch? Have changed ECU, constant voltage regulator and ballast resistor. Ground reading on CPU 0.03 ohms. Electronic set-up installed 8 years ago and all worked fine until lately.
User avatar
Rusty69
Sweptline.ORG Member
Sweptline.ORG Member
 
Posts: 3
Joined: Wed Dec 31, 1969 6:00 pm
Location: Montana

Re: 68 D200 383 w/ECU conversion Voltage problems

Postby dodgeboykim » Wed Mar 22, 2017 8:22 pm

Charge/Battery wire from alternator to battery through dash and bulkhead having issues my guess.
My truck is younger than me.
66 W100. 70 D 500 with 69 Hiab Speed Loader. 96 Ram 3500 Club Cab Cummin's 5 spd. 97 Ram 1500 Club Cab 5.9 gas auto. 83 W200 L/B 360 auto on propane.
User avatar
dodgeboykim
Sweptline.ORG Pioneer
Sweptline.ORG Pioneer
 
Posts: 2231
Joined: Wed Dec 31, 1969 6:00 pm
Location: chilliwack.
City: Chilliwack. B.C. Canada
State: Foreign


Return to *ELECTRICAL SYSTEM HELP*

Who is online

Users browsing this forum: 66Fargocrewcab, Bing [Bot] and 2 guests