High beams not working
- 15austin
- Sweptline.ORG Member
- Posts: 133
- Joined: Fri Mar 20, 2009 7:56 pm
- City: 64836
- State: MO
- Location: SW Missouri
High beams not working
My headlights will only work on low beam. I just put on a new dimmer switch (on the floor) and 2 new headlights. The low beams work fine but when I switch it to high beams the headlights go out. Anyone know a solution? THANKS
1969 D-100 Adventurer (with 70/71 grill), 383/727, Weiand Action Plus Intake, 600 carb, Hedman 79250 Headers, Factory A/C, PS, 8 3/4 (489)with 3.23 gears.
-
- Sweptline.ORG Pioneer
- Posts: 4044
- Joined: Fri Feb 15, 2008 8:46 pm
- City: Wichita Falls
- State: TX
- Location: wichita falls,texas
Re: High beams not working
If the switch is good (and new doesn't always guarantee good) and the headlights are good, then I'd say the high-beam wire is disconnected (not making contact) somewhere between the switch & the headlamps. Or somehow you're losing your ground when on High beam.
All this is assuming no one overhauled/rerouted the wiring in the past.
Bucky
All this is assuming no one overhauled/rerouted the wiring in the past.
Bucky
1966 W500
1975 W600
1978 W200 club cab
1975 W600
1978 W200 club cab
- Trailmaster
- Sweptline.ORG Member
- Posts: 196
- Joined: Sun Oct 04, 2009 1:21 am
- City: Ellicott
- State: CO
- Location: Ellicott, Colorado, USA
Re: High beams not working
Headlights go out could be a short in the wiring blowing the circuit breaker for the headlights.
70 D200 Camper Special 383/727/4:10/AC/PS/PB
74 Trailduster 318/727/NP203/3.55/PS/PB
75 Duster 225/904/PS
76 D300 Adventurer Sport 440/727/4:10/AC/PS/PB/Cruise
74 Trailduster 318/727/NP203/3.55/PS/PB
75 Duster 225/904/PS
76 D300 Adventurer Sport 440/727/4:10/AC/PS/PB/Cruise
- rjmeuer
- Sweptline.ORG Member
- Posts: 135
- Joined: Wed Dec 31, 1969 6:00 pm
- City: St Louis
- State: MO
- Location: St Louis, Missouri
Re: High beams not working
Can hook dimmer switch straight to a battery and headlight to make sure its working correctly?
Ryan, 1967 D100 Long bed with original 383cid B block
--If you support everything, THEN YOU STAND FOR NOTHING!--
--If you support everything, THEN YOU STAND FOR NOTHING!--
- 15austin
- Sweptline.ORG Member
- Posts: 133
- Joined: Fri Mar 20, 2009 7:56 pm
- City: 64836
- State: MO
- Location: SW Missouri
Re: High beams not working
Dimmer switch, headlights are good. I need to check wiring , but Ive just not done it yet.rjmeuer wrote:Can hook dimmer switch straight to a battery and headlight to make sure its working correctly?
1969 D-100 Adventurer (with 70/71 grill), 383/727, Weiand Action Plus Intake, 600 carb, Hedman 79250 Headers, Factory A/C, PS, 8 3/4 (489)with 3.23 gears.
Re: High beams not working
start by checking the plug in conection at the headlight switch on the dash.When the lights go out give it a wiggle and see what happens.
-
- Sweptline.ORG Member
- Posts: 4
- Joined: Mon Feb 22, 2010 5:10 pm
- City: Hermosa Beach
- State: CA
Re: High beams not working
15Austin,
Have you resolved this issue, if so what was the problem/fix? I have the same problem, lights work fine then when i click the high beams (floor switch) the lights shut off.
Have you resolved this issue, if so what was the problem/fix? I have the same problem, lights work fine then when i click the high beams (floor switch) the lights shut off.
- OleRed66
- Sweptline.ORG Member
- Posts: 419
- Joined: Wed Dec 31, 1969 6:00 pm
- City: North
- State: UT
- Location: UT
Re: High beams not working
check grounds. May need to clean up corrosion
1966 Dodge D100 - Ole Red
1993 Jeep Grand Cherokee - The Jeep
1985 Honda Magna - Maggie
2007 Dodge Durango Hemi (wifes) - D
1992 Plymouth Acclaim - Gramma
1993 Jeep Grand Cherokee - The Jeep
1985 Honda Magna - Maggie
2007 Dodge Durango Hemi (wifes) - D
1992 Plymouth Acclaim - Gramma
- 15austin
- Sweptline.ORG Member
- Posts: 133
- Joined: Fri Mar 20, 2009 7:56 pm
- City: 64836
- State: MO
- Location: SW Missouri
Re: High beams not working
No I have not tried to fix it yet. Ive been busy with non-working gauges, oil pan gaskets, timing chain, valve cover gaskets, aluminum intake. But it is in the garage now so I get on it this week.
1969 D-100 Adventurer (with 70/71 grill), 383/727, Weiand Action Plus Intake, 600 carb, Hedman 79250 Headers, Factory A/C, PS, 8 3/4 (489)with 3.23 gears.
- 15austin
- Sweptline.ORG Member
- Posts: 133
- Joined: Fri Mar 20, 2009 7:56 pm
- City: 64836
- State: MO
- Location: SW Missouri
Re: High beams not working
Just fixed the problem. It was the high beam wire going into the fuse box under the hood. Just wiggled the wires and they came on.
These high beams has not worked in 9 years so I am pretty excited.
These high beams has not worked in 9 years so I am pretty excited.
1969 D-100 Adventurer (with 70/71 grill), 383/727, Weiand Action Plus Intake, 600 carb, Hedman 79250 Headers, Factory A/C, PS, 8 3/4 (489)with 3.23 gears.