Really need a pic of tandem brake distribution block!

DarrellG · Post by **DarrellG** » Sat Oct 21, 2006 9:48 pm

Hey guys - I still haven't mounted my 5 way block. I'm not sure which way it goes. On top of the frame rail? My truck's a '65 D200, previously a single master. Got the box at the junk yard (from a '67) but it's been so long ago I don't remember how it mounts!

Any help (a picture would be really cool

) greatly appreciated!

Thanks,
Darrell

DarrellG · Post by **DarrellG** » Sat Oct 21, 2006 9:51 pm

Cool, just found this from the for sale section:

http://cgi.ebay.com/ebaymotors/1968-DOD ... dZViewItem

Looks like the picture I need!

Is this where yours is located too?

devilbrad · Post by **devilbrad** » Sun Oct 22, 2006 4:26 pm

Heres the one on my 67. Note its not bolted down, it bolts to the big hole next to it, LOL Previous owner pulled it out and crimped off the hard line to left front, I'm assuming wheel cylinder is bad. I dont care, gonna convert to IFS and discs anyways.

DarrellG · Post by **DarrellG** » Wed Oct 25, 2006 1:28 pm

Thanks Brad!

Exactly what I needed. That's how I put it (I just banged the dentent tab flat though, no extra slot hole, should be fine...)

Almost there - it's gettin' cold here, I got to hurry! Been running hard lines. My motto - good enough

On the road again? Soon!!!

Pics coming up in a week or so, thanks guys.

Darrell

Russ · Post by **Russ** » Thu Oct 26, 2006 12:56 pm

Here's a pic of my 69. It is tucked into the frame.

I didn't notice the spider webs when I took the pic. I guess I need to drive my truck more.