Master Cylinder Cap
-
- Sweptline.ORG Member
- Posts: 103
- Joined: Fri Jun 30, 2017 8:01 pm
- City: SoCal
- State: CA
Master Cylinder Cap
Is there suppose to be a washer under the bolt that holds down the master cylinder cap on my 61? When the brakes are applied, air bubbles come from around where the hold down bolt goes through the cap.
Re: Master Cylinder Cap
I think there is a washer on my clutch master which may be similar to your brake. Single pot?
jim
jim
-
- Sweptline.ORG Member
- Posts: 103
- Joined: Fri Jun 30, 2017 8:01 pm
- City: SoCal
- State: CA
Re: Master Cylinder Cap
Yes, single pot.
Re: Master Cylinder Cap
It looks copper colored on mine.
-
- Sweptline.ORG Member
- Posts: 103
- Joined: Fri Jun 30, 2017 8:01 pm
- City: SoCal
- State: CA
Re: Master Cylinder Cap
Thanks Jim. When I went to check the fluids, the clutch cylinder didn't have a gasket but the brake cylinder had two. I believe the trucks previous owner must have screwed this up along with losing the washers.