Page 1 of 1
Scare bird thoughts and questions
Posted: Sun Oct 09, 2016 9:36 pm
by greenmachine318
A few years ago I bought everything required to to the conversion before they offered the machined hub assembly. For those of you that have done the conversion how did you do it without their custom hub. My thought on this was obviously saving money. I looked over the extra parts I have laying around and thought I'd give it a shot and pull the hub off an old set up rusted drums I have. So my question is, has anyone thought of doing what I'm going to try and if so does it work?
Re: Scare bird thoughts and questions
Posted: Mon Oct 10, 2016 8:40 am
by earlymopar
Ye, it works doing the swap with OEM hubs or theirs.
- EM
Re: Scare bird thoughts and questions
Posted: Mon Oct 10, 2016 1:25 pm
by greenmachine318
Thanks
Re: Scare bird thoughts and questions
Posted: Fri Oct 14, 2016 8:32 pm
by slick
On the kit I got from you my hubs actually fit in the rotor without clearance issues. I have an extra caliper if you need it..
Re: Scare bird thoughts and questions
Posted: Sat Oct 15, 2016 5:54 pm
by greenmachine318
Thanks slick. I need to link up with you sometime. Do you still have the same number?
Re: Scare bird thoughts and questions
Posted: Tue Oct 18, 2016 11:24 am
by slick
yes
Re: Scare bird thoughts and questions
Posted: Thu Oct 20, 2016 4:14 pm
by sdenty
I have done this swap twice,I just turned the outer edge on a brake lathe until it fit inside the rotor.