I finally replaced the king pins in my 68 D100 and also upgraded to the bearing instead of the stock washers to help steering. it used to take both arms to turn my truck around in a parking lot but not now. with the new bearing upgrade I can do it with one hand! this was an awesome improvement. I also installed new king pins and bushings. I used stock type bushings and not the nylon type you can get now.
I ordered a reamer and put the bushings in myself, it was pretty simple and the whole project took me about 3 1/2 hours from start to finish and go for a test drive. as far as I am concerned this is the only way to go.
king pin replace , bearing upgrade
- Txas2step
- Sweptline.ORG Pioneer
- Posts: 3416
- Joined: Mon May 31, 2010 7:26 am
- City: houston
- State: TX
Re: king pin replace , bearing upgrade
Good news Kenny, I have the same reamer and king pins for my '67.
61 shorty 170/ 3spd 3:91(sold)
66 lwb 318 poly/727/4:10 (sold)
67 shorty 318poly/4spd 3:55
68 ute 318/3 spd/3:55(sold)
70 318/727/3:23
66 d200 225/4spd/4:10( military)(sold)
68 d100 383/727/3:55
66 lwb 318 poly/727/4:10 (sold)
67 shorty 318poly/4spd 3:55
68 ute 318/3 spd/3:55(sold)
70 318/727/3:23
66 d200 225/4spd/4:10( military)(sold)
68 d100 383/727/3:55
- Roxyflash
- Sweptline.ORG Member
- Posts: 705
- Joined: Sat Nov 06, 2010 6:47 pm
- City: East Moline
- State: IL
Re: king pin replace , bearing upgrade
Whats the bearing number you used im going to do my king pins soon
Sweptline Owner From Age 16 to Present
- exline
- Sweptline.ORG Member
- Posts: 219
- Joined: Wed Dec 31, 1969 6:00 pm
- City: warfordsburg
- State: PA
- Location: PA
- Contact:
Re: king pin replace , bearing upgrade
napa part number NCP 2621378 is what I used on my truck , it had the ball bearing instead of the washers. it made the steering wheel easier to turn.