axle measurements...
- fosh69
- Sweptline.ORG Member
- Posts: 744
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Firestone
- State: CO
- Location: Firestone, Colorado
axle measurements...
Does anyone know what the 1/2 and 3/4 ton kingpin to kingpin centers measurement is? What about the spring perch centers? Thanks in advance!
Here you go
Sorry it took so long. Had to wait till help was available and it wasn't pouring Easter bunnies.
From a 66 D100 NOT on a truck at this time: Pin to pin center= 56 3/4 or 57. Depends whos old eyes are looking. I'd believe 57 cause that's what my wife saw. We both got 32 5/8 center to holes in axle at the spring mount.
By the way the wife says you owe her a cup of tea.
Have no D200 to measure but I think they are the same as a D100 or W100-200.
Blue
From a 66 D100 NOT on a truck at this time: Pin to pin center= 56 3/4 or 57. Depends whos old eyes are looking. I'd believe 57 cause that's what my wife saw. We both got 32 5/8 center to holes in axle at the spring mount.
By the way the wife says you owe her a cup of tea.
Have no D200 to measure but I think they are the same as a D100 or W100-200.
Blue