Will it run?
I am building a POS engine for my race truck. It is a 318, with a comp 275 DEH cam, and 596 360 heads milled .060..............hehehe...........
The bottom end is still factory, with used rings.......
Piston is .065 down the cylinder, but, it still should run OK.
I'll post a video when she runs..........
http://i12.photobucket.com/albums/a227/ ... 010023.jpg
http://i12.photobucket.com/albums/a227/ ... 010010.jpg
http://i12.photobucket.com/albums/a227/ ... 010009.jpg
http://i12.photobucket.com/albums/a227/ ... 010014.jpg
OK, I admit, the bearings, rings, and such are used, from different motors.........kinda like whatever would work.
Only thing new is the timing chain, and gaskets, and cam, lifters, and springs.............hehehe, I am such a cheap @#%.
Project POS..................
-
- Sweptline.ORG Member
- Posts: 368
- Joined: Wed Dec 31, 1969 6:00 pm
- City: Big Lake
- State: AK
- Location: Big Lake, Alaska
- Contact:
look's like it will run just fine to me , I did that with a corvair engine once & it lasted over a year for me then I sold it & talk to the guy a few years later & his daughter was driving it to school stll same engine
cowboy Alvin Tx
67 w100 318 3spd
2005 Ram 2500 CC Diesel 4x4 lwb
LAND OF THE FREE
BECAUSE OF THE BRAVE
67 w100 318 3spd
2005 Ram 2500 CC Diesel 4x4 lwb
LAND OF THE FREE
BECAUSE OF THE BRAVE