Engine, transmission, rear-end, driveline, fuel system etc..
1966D100
Post
by 1966D100 » Sun Mar 26, 2006 8:17 pm
I was wondering if the NV3500 5spd out of a 318 powered late model ram would bolt on to and work with the Poly
MountainMoparRobin
Founding Member
Posts: 7854 Joined: Wed Dec 31, 1969 6:00 pm
City: Lakewood
State: CO
Location: Lakewood Colorado
Post
by MountainMoparRobin » Mon Mar 27, 2006 4:41 am
Good question, don't know if anyone has tried
1966D100
Post
by 1966D100 » Mon Mar 27, 2006 9:42 am
Well, is anyone familiar with the bellhousing pattern bolt and shape wise? Did it change? If its the same, then i can work it from there.
Here's the Polys bellhousing pattern (though i know the NV3500 has a molded on bellhousing, i just want to know it'll match up atleast on that aspect)
ozzie
Sweptline.ORG Member
Posts: 435 Joined: Wed Dec 31, 1969 6:00 pm
City: colorado springs
State: CO
Location: colo. spgs. co.
Post
by ozzie » Mon Mar 27, 2006 9:57 am
that doesn't look like a poly bell to me. the opening for the clutch lever is on the drivers side. the polys lever is on the passengers side. it looks like a 69 and up mechanical bell to me. Ozzie.
ozzie
1966D100
Post
by 1966D100 » Mon Mar 27, 2006 10:33 am
hmm, somebody told me it was a picture of a poly bellhousing