NV4500 2wd Rear Mount

[jengel451]

Hey all,

Getting close to shoving the Magnum and NV4500 into the D100. I snagged original Auto rear Cross Member to use, but now for the little details.

Any idea on what Trans to Crossmember insulator mount would work? I'm seeing a lot that "Could" be a potential fit, but nobody lists the trans bolt separation etc.

[marklein]

I used a Chevy mount, but I have a Chevy 2wd output shaft.

[jengel451]

yeah, just sort of found a few that may work. I think I can get some plate and make a quick adaptor for this to work on the trans side, then drill the cross member for the studs.

https://www.autozone.com/drivetrain/tra ... pps.s=3771