1968 W200 Master Clutch Cylinder
1968 W200 Master Clutch Cylinder
I was installing a bad master clutch cylinder when I tried to remove a brass fitting that goes under the "throat" of the plunger. I broke it and have been trying to find a replacement. No luck yet ! I am not sure if that fitting (not the forward one that is a 90 degree fitting that attaches the hydraulic line to the slave) should be a plug or some kind of air passage ?? The existing one just doesn't seem to have a function. Please advise
-
- Sweptline.ORG Pioneer
- Posts: 7339
- Joined: Wed Dec 31, 1969 6:00 pm
- Location: Walnut Creek, CA
Re: 1968 W200 Master Clutch Cylinder
The situation and parts you are describing are unclear due to non-standard terms. Post a pic to help with understanding.