Page 1 of 1
closed knuckle 44
Posted: Fri Nov 22, 2013 5:13 pm
by Jim100
Do the wheel bearings need to be greesed on this axle via taking the hubs apart?
Thanks jim
Re: closed knuckle 44
Posted: Fri Nov 22, 2013 9:22 pm
by dodgeboykim
You bet. A lot more work than a 2 wheel drive though.
Re: closed knuckle 44
Posted: Sat Nov 23, 2013 6:26 pm
by Hobcobble
dodgeboykim wrote:You bet. A lot more work than a 2 wheel drive though.
Yes indeed!
John
Re: closed knuckle 44
Posted: Sun Nov 24, 2013 7:29 am
by Jim100
Great. How many of the hex bolts holding in the locking bit are going to snap or round out? If I have not greesed the bearings in a long time then I am sure they are due ? Several years.
Thanks guys.
Jim
Re: closed knuckle 44
Posted: Fri May 16, 2014 9:52 am
by gotAgreenMachine
And if I have broken the nuckle housing where would be a good start to find a replacement? Dana 44hd 3000 casting # c31412
Re: closed knuckle 44
Posted: Fri May 16, 2014 11:56 am
by dodgeboykim
Re: closed knuckle 44
Posted: Wed May 21, 2014 2:34 pm
by 67cspowerwagon
I have both for sale 67 dana 44 and a 74 with disc brakes both 4.09 gear