Does anyone know if it is possible, without removing the unit, to install the 4x4 powerwagon transmission output shaft that rests on crossmember onto the transmission in a d-100? This may sound weird but I am researching ways to move all the 4x4 parts from one truck onto a d-100 with a good motor and am looking at the variables with least amount of lifting and moving heavy things.
Thanks all.
jim
output shaft swap?
Re: output shaft swap?
Sorry,Jim, you have to dissemble the tranny to remove the output shaft.
Re: output shaft swap?
Looks like the transmissions will have to swap. I suspect different splines on input shaft so I will have to then replace the clutch which is probably a good thing anyway. Is it possible to replace the clutch from the bottom through that removable plate without taking the bellhousing off? Sorry for these ignorant questions.
jim
jim
Re: output shaft swap?
1968 and back = 10 spline input
1969 and up = 23 spline input
Yes you can service clutch without removeing bell.
1969 and up = 23 spline input
Yes you can service clutch without removeing bell.