Carter 9626sa

Engine, transmission, rear-end, driveline, fuel system etc..
Post Reply
Caleray
Sweptline.ORG Member
Sweptline.ORG Member
Posts: 15
Joined: Sun Oct 29, 2017 2:36 pm
City: Laporte
State: IN

Carter 9626sa

Post by Caleray »

Im trying to figure out which carburetor to use on my 273. Is a Carter 9626sa a good choice for the engine? Will this work ok with a four-speed?

User avatar
Txas2step
Sweptline.ORG Pioneer
Sweptline.ORG Pioneer
Posts: 3416
Joined: Mon May 31, 2010 7:26 am
City: houston
State: TX

Re: Carter 9626sa

Post by Txas2step »

Do you have a 2 barrel or four intake? Carter BBd if 2 barrel/ I have a Edelbrock 1403 ( 500 cfm) on my 1965 273 Dart. That's all the little motor needs. :2cents :Thumbsup
61 shorty 170/ 3spd 3:91(sold)
66 lwb 318 poly/727/4:10 (sold)
67 shorty 318poly/4spd 3:55
68 ute 318/3 spd/3:55(sold)
70 318/727/3:23
66 d200 225/4spd/4:10( military)(sold)
68 d100 383/727/3:55

User avatar
MadMC63
Sweptline.ORG Member
Sweptline.ORG Member
Posts: 794
Joined: Sat Nov 14, 2015 12:16 pm
City: Rome
State: GA

Re: Carter 9626sa

Post by MadMC63 »

I believe that's a AFB 625 CFM carb. Should be fine.
1971 Dodge D100
So what's wrong with setting beneath a single pull string incandescent light bulb writing angry letters?

User avatar
MadMC63
Sweptline.ORG Member
Sweptline.ORG Member
Posts: 794
Joined: Sat Nov 14, 2015 12:16 pm
City: Rome
State: GA

Re: Carter 9626sa

Post by MadMC63 »

Couldn't send a pic with the PM so here's what I was talking about.
Throttle linkage stud.jpg
Throttle linkage stud.jpg (10.5 KiB) Viewed 360 times
Throttle cable on the left kickdown on the right.
1971 Dodge D100
So what's wrong with setting beneath a single pull string incandescent light bulb writing angry letters?

Post Reply