Sweptline.ORG

I had to replace the ring and pinion in my 67 Dana 44 front. I bought the ring and pinion but had to buy one with 26 splines and the old was 10, I think. My problem is now I need a new pinion yoke with 26 splines. Cannot find one for the 5380 u joint only 1310, 1330 and 1350. The only conversion u j...

Tried them. I guess it is kind of an old style fastener. Most of the flexlocks that I find are the light variety. The old ones are very heavy duty.

Does anyone know of a source for the 3/4-16 flexlock nuts that go on the spring bolts? If not can you suggest a replacement type of nut. Thanks, Jon

Braden still sells the handle through Braden/Paccar dealers for just over $300. If you have the shift fork and can weld, I can provide the specs for the rest of the handle. Jon

Cool. Thanks, Jon

Anybody know of a soure for front and rear leaf spring bushings for a 1967 w200. Thanks, Jon

No, I am sure it is the PTO cable. And it is long enough to go from the transfer case, which it was attached to when I got it, througt the firewall and to the dash. I would love to find a factory locking throttle cable. I seem to remember seeing a photo of one that was mounted in the dash below and ...

I just picked up a factory winch setup for my 65 w200. I got the frame extensions, pto, shafts, bearings, winch and PTO control cable. Does anyone have pictures of where the control cable mounts in the dash and where it penetrates the firewall. Thanks, Jon

vintage power wagon list a bearing set for this pto @ $91.50 but no seals.

Anybody out there rebuild a FTD7 PTO off of a NP 201 transfer case? I'm looking for current part numbers for bearing and seals and gaskits before I pull it apart. I know Braden does not supply parts for these any longer but there must be compatible bearings and seals that cross reference over. If no...

Braden does indeed have the part but the handle assembly goes for over three hundred dollars. A little steep in my opinion.

I've got an LU-2 winch on a 1967 w200 on which the handle that engages the winch is broken off and missing. I think that I can make one if II knew what it was suppose to look like. Does anyone have a diagram with demensions ? Thanks, Jon

I found one local and have purchased it. Thanks

Im looking for a NP 201 transfer case for a 65 W200. It is a two lever tc with the large 10 bolt PTO opening. I'm in North Idaho.