Sweptline.ORG

Well its been awhile due to me not working on my truck but Mark at Scarebird went above and beyond once he realized what the problem was. Send me the right seals basically overnight. Great company to do business with.

Looking good, I like this. I just Tuesday received my axle back from Sid with the blocks, might return them for this set up.

Ryan I just used the same part. You must cut the entire top hole off and I had to trim both lower sides down to the bushing. Additionally if you have lowered any additional it is best to drill out the front spring carrier and move it also to correct your pinion angle.

Mounts and brackets are available from several aftermarket vendors.

Well I didn't take a photo so got that out of the way, On a 1969 three speed transmission does the mounting holes for the transmission go to the front or rear of the crossmember when installing it back on the frame?

You the man!

Thanks Jim I will give a measure and check those numbers.

I ran the search every way I could think off, no luck. I'll just measure down once I get the bed set on if no one can give the the height.

Well the wife has helped clean my garage and threw away my front two oak blocks, does anyone have them out to give me some measurements?

Are fuel lines the same on 66 to 69 trucks? Tank to pump.

The Right Stuff has all new if you need them.

My truck has been driven less than 50 miles after the disc install. Both front seals ate up, National 472070 bought locally and used with the provided bearing and hub from Scarebird. I had told Mark that they didn't look like they seated correct when we installed them. Any ideals, I have emailed Mar...

Can someone tell me or post a picture where the dip stick tube on BIG BLOCK bolts to?

RobertGilliam Clinton Tennessee

I bought a bent Torq Thrust to match my truck wheels and cut it in half, wala.

SWEEEEEEEEEEEEEEEEEEEET!

Ok So when we took off my bed two metal shims fell out, not sure which wood blocks they were under, does anyone know? Thanks

Me toooooooooooooo!

Welcome, not to much to worry about as far as parts go. Replacement panels are available from Kenny Exline on here, American made and the best there is at an affordable price. Good luck.

Roger that, many thanks!