Sweptline.ORG

I would start looking at 4" stroke crankshafts for a small block If I was thinking about a 4500.

724-791-2514

Bruce Toth is selling an flange that bolts to the poly that adapts a 331-392 shorty header. Sorry if this has been posted before but I saw it last weekend and thought it was a neat piece.

round taillights and chains is about all I can tell you

I cut the frame down on my 65 D100 from the factory 122wb to 114. I took the 8 inches out about 2 inches behind the front bed mount and then going to the rear on the long straight section. I splined the frame sections together, butt welded it, plated it and boxed it with the offal. Checked work with...

Early

I am putting a 91 360 in my 65 D100 and am curious as to engine brackets and insulators. Does the /6 and 318 use the same insulator? The 360 was out of a B350 and the bracket is too short, after slotting the bracket enough to get the bracket to lie fast to the insulator the motor is too low and belo...

You could have a radiator shop fab one up

It was the rear. IIRC it had rotors. So even if it was all RH thread you would think after 2 snapped you would stop and reassess what your doing.

I wasn't going to start posting on here until I started work on my truck but last wed or thurs I passed a old Dodge broke on the side of the road, As I went by it I saw it was 62-5 that looked like the CB truck I pulled over and walked back and it was it. 528 in the grill, Radirs, Fake old logos, Zo...