Sweptline.ORG

who sell the best fitting carpet for the best price? I have a 63 w200 crew cab.

nobody??

I have a 1963 w200. It had a slant 6 with a 4 speed. The clutch pedal pushes in hard and when I let up on the pedal, it comes back slowly.

im putting a 383 in my 70 crew cab. the 383 came out of a 74 power wagon. do the motor mounts have to be in front or behind the ears on the block?

Are the frames the same on half, 3/4, and 1 ton trucks?

thanks guys!

how does the shifter handle come off the top of my 4 speed? do I knock that roll pin out? and is the backup switch harness different from a 4 speed to an automatic? thanks guys!

I just pulled a 383 and automatic out of a 1974 power wagon. the oil pan is a rear sump. there was plenty of room. But everything I read says i need a front sump pan to put this engine and tranny in my 1970 w200 crew cab. will this setup work as it is?

yes it is a divorced transfer case

I have a 1970 dodge crew cab 4x4. it has a 318 with a 4 speed. I found a 1974 powerwagon with a big block and automatic. will the big block and auto trans bolt into my 70?

im asking about the w series. So its just the rear lift blocks? I want my 70 crew to sit as high as the pre 69s

why do they?

Is it just me or does it seem like the 68 and older 3/4 ton trucks sit higher in the air than 69 thru 71?

has anyone ever swapped a 72 and newer driveline into a swepty? im looking at a 2 wheel drive 1968 crew cab. I can also buy a 1973 3/4 ton 4x4 dodge. I was thinking of doing some swapping

How rare are 19.5 wheels? I might buy truck with them on and I am not a fan of them. I will sell them if I get the truck bought.

bigks3, Kenny from Little Rock, Iowa

I have a 32ft travel trailer. Im looking to buy a 1967 w200 crew cab with a 6cyl and a 4 spd. will this truck pull my camper?

will a 69to 71 hood fit on my 67 with a pieplate grill? I like the raised hood look better