Sweptline.ORG

Will a torqueflite 727 bolt to the 318 poly sphere my starter on mine is mounted to the bell housing that's why I'm a little concerned about the transmission swap

You take off a canister and remove a paper filter surrounded by a wire mesh cage

I'm using the stock OEM filter. I started it up this morning pressure on the gauge is now past 120 psi what is going on

OK a new problem has come up oil pressure is up past 90psi. Just did an oil change 10w30 mobile one. From cartridge filter don't have the numbers it was around 40 to 50 psi after the oil change but now it just shot up. I hooked up a second oil pressure gauge to see if the dash gauge was broke but I ...

Got so many cracked and bare wires be hind the dash and my head light switch is broken where can I get one

Curiosity has set in. What other transmissions will bolt to the bell housing. The original is a new process 420. Thanks to all who have helped me thus far.

10si sorry

Some one used rtv silicone for the intake manifold its leaking oil quite a lot. So my next question would be is can I use an intake manifold gasket from a newer 318 poly sphere or do I need to get a specific gasket. And would it be better just to put a delco Remy 10 so on my truck my voltage regulat...

The engine in it is a 318 polysphere. The tag says trans 4 syn make n process model 420 d but I can't seem to find any thing on the internet

Also what is the name and model of the 4 speed transmission in my truck there's no inspection plates on the driver side it is a four speed with a PTO box on the bottom passenger side of the transmission

They took a power steering system off of a 81 d250 truck and they took off the old brake booster on the frame rail and put a brake booster and master cylinder from the same 81 d250 surprisingly it works very well brakes are nice and crisp and the steering I can turn it with my pinky

The previous owner when through and gutted all the electrical repainted the whole truck upgraded the steering and brakes I can get the engine numbers Tomorrow but there's no fuse box any where the engine electrical still works but no head lights on low. I'm still trying to find what transmission I g...

Thank you sorry about the grammar I did the typing during break at work my phones auto correct is to sensitive the electrical diagram is perfect still trying on getting information on the transmission.

Will this diagram work for a 63 d500

I bought a 1963 dodge d500 for 100 bucks engine runs great trans works good to but where can I get parts for a 318 industrial and what is the model of the trans in it I also could use an electrical schematic for it for some reason when I hit the brakes my head lights flash and the headlights don't w...