Sweptline.ORG

Its 100% my fault. They responded immediately. My email just marked them as junk

Thanks again all

Hobcobble wrote: ↑

Tue Oct 31, 2023 10:36 am

Try Bud Thorp at:
www.dodgesweptlineparts.com

John

Is there a secret to get a response through his website? Ive made alot of inquiries but never hear a thing back.

Thanks!

Just curious if any of y'all may have the inspection cover for the 318 with np435 set up? Its the last real missing piece I kinda need before to much driving around.

Thanks,

Derek

PwrWgnDrvr wrote: ↑

Sun Oct 22, 2023 8:43 pm

Ya, that clip is easy to miss. Glad you figured it out! (I don't have a pic of it)

No worries about the photo. I appreciate you mentioning that. Been fighting it for a week at least now trying to figure out what I was doing wrong.

Thanks a bunch!

Clutch fork does have the retaining clip. I think i was not getting the clutch fork far enough in for the clip to latch. Couple taps with a hammer and its on. Got a new alternator bad out of the box so once that gets situated tomorrow I believe the truck can have its maiden voyage.

There is a retainer clip on the clutch fork that holds it to the pivot ball. Sounds like that is where the problem is. Do you by chance have a photo? I dont have a retainer clip for sure. Seems like the throwout bearing is rotating slightly and then when i go to engage the clutch the fork slips com...

Does anyone possibly have a photo of inside your bell housing? Specifically the clutch fork ball on the 4 speed manual. I got a new clutch in there and now that its back together the clutch fork slips off the throwout bearing and causes the clutch pedal to stick down. I did have to bend back the cli...