Sweptline.ORG

on how to change the bearing in the steering column of a 66 d100 and where to get one. Thanks. Bob

I've welded my cab mounts, but I may not have gotten the cab jacked up enough. What do you think if I loosen the column bolts and pull up? Would that help? Could it screw anything up?

Thanks. The sound seemed like it came from the top. I spray WD40 up the column and it still catches but doesn't make the same sound. How do you change the bearing and where would I get one? Bob

66.5 d100. It catches, sound like a scrape. It's not in the box, which was rebuilt. Any ideas?

65.5 They used to work okay before I stripped my dash to paint it. After washing down the dash, the switch locked up. One of you guys sold me another, but it only ran on high, overheats, and quits. I got another, but the push clip rivet for a connection didn't stay inside the body. Both switches loo...

any recommendations on replacements. I can't afford or find originals and would like to know where to drill before I finish the body work. Some I've looked at don't fit right because of the curve at the top. Thanks Bob

66 d100: I can't find (afford) original. Does anybody have a rec on mirrors other than? You guys know the curve and nothing I've looked at seems cool. It's a wide enough truck already and big mirrors look too weird for me. The orig. was correct, but any recs would be appreciated. Please include wher...

What year wiper switches would match up with a 66d100? Thanks.

3 speed on the column

Thanks == wish I could find a wiper switch. Bob

66 D100: Anybody got advice on removing the knobs, especially the vent cables. Bob

-- 66d100 -- when slowing down to stop. It's done it for a couple decades and I haven't cared because I had to put it in neutral anyway. My throwout bearing is clicking, so I thought I'd ask about the sync, I guess that's what it is. Can one still buy trans parts new? I know a great trans guy. He ca...

It seems kinda hard, but I'll give it a try. What's the odds since I don't have the tools you mentioned? I've printed out your instructions. Do you have a recommendation on where to get parts? I've been burned by NAPA before, and don't want the thing apart and the parts don't match. Thanks again. Bo...

66 D100 I guess its a grease seal. I've parked my truck on a slant for a while to do body work. Yesterday, I took off the rear bumper and noticed grease running down the passenger side rear tire. What do I need to do to fix it? Any special tools? Any recommondation on getting the part, or anything e...

...three left and if you don,t mind waiting pm me with your address and I will mail you one. Joe[/quote] Joe, Thanks so much. I got the nut today. I put it into the square with most of the nut sticking outside the hole. Is that right or should I turn it around? What length bolt would be best? Let me...

you actually BOUGHT something instead of whineing about cost!!,i cant believe it!! butch romig Butch, I've bought lots of stuff. You're just pissed because I didn't buy your pan that was junk and you should have been embarrassed about trying to sell int the first place. Get over it. Do you have the...

I bought a fender off the site. What kind of bolt do I use for the square hole close to the door at the top? Does anybody have one or know where I can get one and how to put it on? Thanks.

Bobcatt

I saw the post on king pins. I've replaced mine a couple of times. However, the play that I have seems to be in the axle rather than the bushings. Short of replacing the axle, does anybody have any recommendations? This guy said that swedging might fix it. How is that done? Bob

I'm about ready to buy a 67 passenger side fender to replace my dented 66. Will it be a perfect match?

robert_t@charter.net